Cm-et Hurricane 360 User Manual download pdf (Page 12)

128

Maintenance (Continued)

GEARS

The gears (656-12A and 656-12B)

do not have to be timed and as a result,

they do not have to be oriented

n a certain position during assembly.

owever, for proper operation of the

1/2, 1, 3, 5 and 10 ton units, one gear

marked “A” and one gear marked “B”

must be used.

PREVENTIVE MAINTENANCE

In addition to the inspection procedures,

a preventative maintenance program

should be established to prolong the

useful life of the hoist and maintain

its dependability and continued safe use.

The program should include the periodic

inspections with particular attention

being paid to the lubrication of various

components using the recommended

lubricants (See Figure 8).

TESTING

Prior to initial use, all repaired or used

hoists that have not been operated for

the previous 12 months shall be tested

by the user for proper operation.

Test the unit first in the unloaded state

and then with a light load of 100 lbs.

times the number of load supporting

arts of load chains to be sure it oper-

ates properly and the brake holds the

load when the hand chain is released;

then test with a load of 125% of its

rated capacity.

In addition, hoists in which load

sustaining parts have been replaced

must be tested with 125% of rated

capacity by or under the direction

of a designated person and a written

report prepared for record purposes.

NOTE: Because this hoist is equipped

with a load limiting device occasional

slipping of the handchain wheel may

occur when testing with 125 percent

of rated load.

NOTE: For additional information

on Inspection and Testing refer to

ASME B30.16,”Overhead Hoists”,

obtainable from ASME Order

Department,

22 Law Drive, Box 2300, Fairfield, NJ

07007-2300, U.S.A.

INSPECTOR’S REPORT

ITEM REMARKS (LIST DEFICIENCIES AND RECOMMENDED ACTION)

Inspector’s Date

Signature Inspected Approved by Date

Figure 7 - Recommended Inspector’s Report

RECOMMENDED LUBRICATION SCHEDULE*

HURRICANE 360 HAND HOIST

KEY NO. COMPONENT TYPE OF LUBRICANT ** ORDER TYPE OF SERVICE AND

(SEE PAGES PART NO. FREQUENCY OF LUBRICATION

(12 & 13) HEAVY NORMAL INFREQUENT

656-28 Load Chain Lubriplate

Bar and 28619 Daily Weekly Monthly

Chain Oil 10-R (1 gal. can)

656-11 Gears and

656-12 Bearing Surfaces 28629 When hoist is disassembled for cleaning

656-13 of Upper Poliplex 2 (1 lb. can) or repairs

656-17 and Lower

Hook Knobs

* This lubrication schedule is based on a hoist operating in normal environment conditions. Hoists operating in adverse

atmospheres containing excessive heat, corrosive fumes or vapors, abrasive dust, etc., should be lubricated more frequently.

** See page 12 for ORDERING INSTRUCTIONS.

Figure 8 - Recommended Lubrication Schedule

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Comments to this Manuals

No comments

Cm-et Hurricane 360 User Manual Page 12

Comments to this Manuals

Related products and manuals for Hoist Cm-et Hurricane 360