Cm-et Series 622 User Manual download pdf

Note: When ordering parts, always furnish rated load and serial number of hoist on

which the parts are to be used.

For the location of the nearest CM Master Parts Depot, see the list located on the

inside front cover.

Columbus McKinnon Corporation • Industrial Products Division • 140 John James Audubon Parkway

Amherst, New York 14228-1197 • 1-800-888-0985 • Fax 716-689-5644

LIMITATION OF WARRANTIES, REMEDIES AND DAMAGES

THE WARRANTY STATED BELOW IS GIVEN IN PLACE OF ALL

OTHER WARRANTIES, EXPRESS OR IMPLIED, OF

MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE,

OR OTHERWISE, NO PROMISE OR AFFIRMATION OF FACT

MADE BY ANY AGENT OR REPRESENTATIVE OF SELLER

SHALL CONSTITUTE A WARRANTY BY SELLER OR GIVE RISE

TO ANY LIABILITY OR OBLIGATION.

Seller warrants that on the date of delivery to carrier the goods

are free from defects in workmanship and materials.

SELLER’S SOLE OBLIGATION IN THE EVENT OF BREACH OF

WARRANTY OR CONTRACT OR FOR NEGLIGENCE OR

OTHERWISE WITH RESPECT TO GOODS SOLD SHALL BE

EXCLUSIVELY LIMITED TO REPAIR OR REPLACEMENT, F.O.B.

SELLER’S POINT OF SHIPMENT, OF ANY PARTS WHICH

SELLER DETERMINES TO HAVE BEEN DEFECTIVE or if Seller

determines that such repair or replacement is not feasible, to a

refund of the purchase price upon return of the goods to Seller.

Any action against Seller for breach of warranty, negligence or

otherwise, must be commenced within one year after such

cause of action occurs.

NO CLAIM AGAINST SELLER FOR ANY DEFECT IN THE

GOODS SHALL BE VALID OR ENFORCEABLE UNLESS

BUYER’S WRITTEN NOTICE THEREOF IS RECEIVED BY

SELLER WITHIN ONE YEAR FROM THE DATE OF SHIPMENT.

Seller shall not be liable for any damage, injury or loss arising

out of the use of the goods if, prior to such damage, injury or

loss, such goods are (1) damaged or misused following Seller’s

delivery to carrier; (2) not maintained, inspected, or used in

compliance with applicable law and Seller’s written

instructions and recommendations; or (3) installed, repaired,

altered or modified without compliance with such law,

instructions or recommendations.

UNDER NO CIRCUMSTANCES SHALL SELLER BE LIABLE

FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES AS THOSE

TERMS ARE DEFINED IN SECTION 2-715 OF THE UNIFORM

COMMERCIAL CODE.

INDEMNIFICATION AND SAFE OPERATION

Buyer shall comply with and require its employees to comply

with directions set forth in instructions and manuals furnished

by Seller and shall use and require its employees to follow

such instructions and manuals and to use reasonable care in

the use and maintenance of the goods. Buyer shall not remove

or permit anyone to remove any warning or instruction signs

on the goods. In the event of personal injury or damage to

property or business arising from the use of the goods, Buyer

shall within 48 hours thereafter give Seller written notice of

such injury or damage. Buyer shall cooperate with Seller in

investigating any such injury or damage and in the defense of

any claims arising therefrom.

If Buyer fails to comply with this section or if any injury or

damage is caused, in whole or in part, by Buyer’s failure to

comply with applicable federal or state safety requirements,

Buyer shall indemnify and hold Seller harmless against any

claims, loss or expense for injury or damage arising from the

use of the goods.

SOLUTIONS

OPERATING,

MAINTENANCE &

PARTS MANUAL

HAND OPERATED

CHAIN HOIST

Price: $5.00 Manual No. B622-B

Before installing hoist, fill in the

information below.

Rated Load __________________

Serial No. ____________________

Purchase Date _______________

22950

Rated Loads:

1/2, 1, 2, 3, 5 and 10 tons

(500,1000, 2000, 3000, 5000,

and 10,000kg.)

Follow all instructions and warnings for

inspecting, maintaining and operating this hoist.

The use of any hoist presents some risk of personal

injury or property damage. That risk is greatly

increased if proper instructions and warnings are not

followed. Before using this hoist, each operator

should become thoroughly familiar with all warnings,

instructions and recommendations in this manual.

Retain this manual for future reference and use.

Forward this manual to operator.

Failure to operate equipment as directed

in manual may cause injury.

SERIES 622

SS 1/00

eries

622

1 2 3 4 5 6 ... 10 11

Summary of Contents

Page 1

Page 2

9SERIES 622 HAND HOIST PARTS LISTHandwheel Cover with Studs622-1622-2622-3622-4622-5622-6622-7622-8622-9622-10622-11622-12622-13622-14622-15622-16622-

Page 3

10PART NUMBERS FOR PACKAGED LUBRICANTSUsed in the Series 622 Hand Hoists(Refer to page 6 for Lubrication Instructions)Lubricant UsageGears, Rollers of

Page 4 - WARNING

CM HOIST PARTS AND SERVICES ARE AVAILABLE IN THE UNITED STATES AND IN CANADAAs a CM Hoist user, you are assured of reliable repair and parts services

Page 5 - GENERAL INFORMATION

Page 6 - MAINTENANCE

3SAFETY PRECAUTIONSEach Series 622 Hand Hoist is built in accordance with the specifications contained herein and at the time ofmanufacture complies w

Page 7 - LUBRICATION

OPERATING INSTRUCTIONS4This manual contains important information to help you properly install, operate andmaintain your Series 622 Hoist for maximum

Page 8 - 10 Ton Hoist

WARNINGAllowing the load to bear against the hook latch and/or hook tip can result inloss of load.TO AVOID INJURY:Do not allow the load to bear agains

Page 9 - ORDERING INFORMATION

6Hoist Rated LoadTons (Kg.)1⁄2 (500)1 (1000)2-10(2000-10000)Hand ChainChain StockDiameterIn. (mm)0.197 (5)0.236 (6)0.394 (10)0.194 (4.9)No. ofLinkstoG

Page 10 - PARTS LIST

72. The latch is secured to the hook (upper and lower) by a rivet. To remove the latch, it is necessary to remove the head of the rivet by grinding o

Page 11 - Exploded View

8REEVING 3 and 5-Ton HoistDEADENDBLOCK113422DEADENDBLOCKLOOSEEND PINLOOSEEND PINREEVING 10-Ton HoistEXTERIOR FINISHThe exterior surfaces of the hoists

Comments to this Manuals

No comments

Cm-et Series 622 User Manual

Browse online or download User Manual for Hoist Cm-et Series 622. CM-ET Series 622 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hoist Cm-et Series 622